What are the structural characteristics of miniature magnetic pumps?

　　Miniature magnetic pump is designed without shaft seal, the pump body is completely sealed, completely solved the traditional mechanical shaft seal pump can not be avoided bubbles, bubbling, dripping, leakage of the disadvantages of the miniature magnetic pump optimized structural design, the impeller and the magnet one-piece molding in high-speed operation and high temperature is not easy to damage.

Miniature magnetic pump product features:

　　Miniature magnetic pump because of its special structure and pump body materials with high temperature resistance (resistant to 100 degrees high temperature)!

　　The pump body is made of environmentally friendly engineering plastic materials (FRPP\PVDF), with corrosion resistance, acid and alkali resistance, environmental protection and other advantages.

　　Short and compact performance: miniature magnetic pump bushings are made of high-precision ceramics, which can be used for continuous working life, stable performance, high efficiency, and can be used for up to 12 years or more.

　　1, magnetic pump bearing lubrication and cooling is dependent on the medium being transported, in the work of the prohibition of idling, while avoiding the work encountered in the power outage situation, restart again will cause no-load operation.

　　2, if the transportation of media containing particles of solids, the pump inlet to add a strainer, if containing ferromagnetic particles, need to add a magnetic filter.

　　3, miniature magnetic pump in use, the ambient temperature should be less than 40 degrees, while the higher temperature of the motor can not exceed 75 degrees.

　　4. The temperature and medium to be conveyed by the miniature magnetic pump should be within the permissible range of the pump material. The use temperature of the metal pump <100 ℃, the use temperature of engineering plastics <100 ℃, the density is not greater than 1600Kg/m3, conveying suction pressure is not greater than 0.2MPa, the large working pressure of 1.6MPa, the viscosity is not greater than 30X10-6m2/S of the liquid and hard particles that do not contain fibers.

　　5, miniature magnetic pump should be cleaned in time after use for conveying liquid for easy precipitation and crystallization of the media, and timely discharge of residual liquid

　　6、After 1000 hours of operation, the miniature magnetic pump should be disassembled to check the wear and tear of the bearings and end rings, and replace the wearing parts in time.